Laminate Floor: How to Install It Properly

A lot of people are so fond and used to doing things on their own. That includes the installation of their own floors. This article will hopefully provide you a very good idea on your own laminate floor how-to project.

Laminate Floors: How to Make It Work

Usually, you should look for a professional who definitely has the knowledge and experience on how to install laminate flooring. Nevertheless, if you want to go on with how to install laminate floor on your own or do the laminate floor how-to project, you can take note of the following steps:

1. Start with a very clean room—literally. It is always best to start your laminate floor how-to project in a house that is still under construction since you can have more freedom on how to move about the floor. Also, you don’t need to think of moving furniture or hitting doors in the process. However, if you’re remodeling your property, it would be a good thing to start how to install wood laminate floor by removing the moldings, doors, and baseboards that can get in the way.

2. Check that the floor is even. Ensure that the floor is even and that there are no humps or bumps before you attach the laminate floors. How to do it is very easy. Look for any floorboard that is squeaking or extremely loose. You should also remove the tacks that have been attached to the floor because of your carpets.

3. Add the underlay or use a plastic sheet. Before you go on, try to remember how you want to install your laminate floors. You can have it floated, or you can directly attach it to the subfloor. Normally, the procedure in a laminate floor how-to project involves the installation of the underlay, which is actually made up of wide rolls that are taped together (use a duct tape). But if you want to directly put it on top of the concrete subfloor, you have to make use of the plastic sheet to avoid the vapor from rising into the laminate or into the underlay.

4. Place the first boards. On your laminate floor how-to activity, determine which wall you are going to start, and begin placing the laminates. Normally, just to make sure that the width is very even, you may have to rip the first board. If you don’t like to do that, you can simply cut the groove. While you’re doing your laminate floor how-to project, you must also watch out for the distance between the wall and the floor. Make sure that you can provide at least a gap of 0.25 inches. Your flooring will undergo changes, such as expansion, so you would want to leave room for that.

In your laminate flooring how-to activity, there are a couple of things that you have to remember, and one of these is the size of the door. You may have to eventually remodify it, such as remove some portion of its base, to avoid hitting the floor directly. It will cause scratches and place too much pressure on your laminates.